Wilson Electronics 801106 Wireless 60 dB Gain Amplifier / Repeater for buildi...

Wilson Electronics 801106 Wireless 60 dB Gain Amplifier / Repeater for buildi... Review

See more picture

Wilson Electronics 801106 Wireless 60 dB Gain Amplifier / Repeater for buildi... Feature

• Works on all generations of CDMA, TDMA, GSM and 3GSM
• Power control logic ensures maximum output power is within cellular standards
• Carrier-friendly installation switch assures proper antenna separation preventing oscillation
• Greatly increases signal strength inside your home, improving voice and data quality
• Allows for simultaneous use of multiple devices such as cell phones, notebooks and PDAs

Brand New Wilson 60dB In-Building Wireless Cellular Channel A Smart Technology Amplifier. Model # 801108. The 800MHz Channel A Wireless Signal Booster - Amplifier / Repeater greatly improves signal strength inside a building when using your cellular phone. It does this with no physical connection to your phone, allowing you to walk freely during a call. It even allows multiple phones to be used simultaneously. . The signal is received by the outside antenna from the cell site. It is then amplified and repeated to your phone through the inside antenna providing the best cellular reception. When the phone transmits it is received by the inside antenna. It is then amplified / repeated to the cell site through the outside antenna. *Requires indoor and outdoor antennas, cable and connectors . Features:. Maximum 3 Watts Output Power ; High Power Output Allows More Users On the System ; Low Cost Solution with Uncompromised Performance ; Automatic Gain Control to prevent oscillation or overload ; Automatic Shutdown on overload ; LED Indicators: Power, Oscillation, AGC ; FCC Approved ; Specifications:. Frequency - 824-835 Uplink 869-880 Downlink ; Gain (up/down)- 60 dB / 60 dB ; Max Output Power - 3 Watts ; Max RF (up/down) - +30 dBm / +30dBm ; Noise Figure (down)- 3 dB nominal ; Flatness (up/down) - +/- 2.5dB / +/-2.5dB ; Isolation - Uplink/Downlink more than 90dB ; Power Requirements - 120 V AC, 3 A max ; Connectors - N-Female 50 Ohms ; Dimensions - 5.6 x 3.6 x 1.7(inch) ; Weight - 1.5 lbs ;

Check price now

Rerate Products

Customer Review

Oct 31, 2011 01:49:04

JL AUDIO e1800d Mono Channell e-Series Class D Amplifier

JL AUDIO e1800d Mono Channell e-Series Class D Amplifier Review

See more picture

JL AUDIO e1800d Mono Channell e-Series Class D Amplifier Feature

• High-Damping Class D Circuit with discrete control circuitry
• 800 W RMS x 1 @ 2 ohm (12.5V)
• 480 W RMS x 1 @ 4 ohm (12.5V)

This JL Audio amplifier is truly a breakthrough in technology! Think about it, while installing your new amplifier , you don't even have to worry about a remote turn on wire. This great little amplifier senses it , and turns it on automatically! Not only that, you don't even have to worry about how many ohms you are running your subs, the amplifier senses and runs it accordingly! How's that for technology? This is truly a breakthrough in car audio!

Check price now

Rerate Products

Customer Review

Oct 29, 2011 15:15:05

PowerBass PS-WB112 12-Inch Loaded Bass Enclosure Woofer (Single)

PowerBass PS-WB112 12-Inch Loaded Bass Enclosure Woofer (Single) Review

See more picture

PowerBass PS-WB112 12-Inch Loaded Bass Enclosure Woofer (Single) Feature

• 12-Inch Woofer in a heavy-duty factory tuned non-resonant enclosure wrapped in two tone aviation grade vinyl covering
• Bass reflex single port system woofer featres 2-layer Black ribbed paper cone with DDC finish
• BASV High temperature voice coil
• Double pressed and treated foam surround
• 275W RMS/550 Watts peak power handling 4-Ohm system impedance

PowerBass PS-WB112 is an exceptional loaded autosound enclosure with one 12-Inch woofer in a factory tuned enclosure constructed from non-resonant 5/8-Inch panels and finished in a stylish two tone RFG aviation grade vinyl that will compliment most cargo spaces. Featuring heavy duty box design, bass reflex dual port system, 2-layer Black ribbed paper cone treated with DDC (Dynamic Dampic Coating), BASV high temperature voice coil, double pressed and treated foam surround, double bass circuitry, computer optimized acoustic chamber perfectly tuned for the car environment for a tight and accurate bass response. Also featuring Venturi flared port tube, 550 watts peak power handling (275 W RMS) and 4-Ohm system impedance.

Check price now

Rerate Products

Customer Review

Oct 28, 2011 06:01:04

Soundstream RUB1.700 1x400 Mono Block Amplifier (Blue)

Soundstream RUB1.700 1x400 Mono Block Amplifier (Blue) Review

See more picture

Soundstream RUB1.700 1x400 Mono Block Amplifier (Blue) Feature

• Midnight Blue Finish w/ Brushed Accents
• Regulated MOSFET Pulse Width Modulated Power Supply
• Three-Way Protection Circuitry (thermal short impedance) Twin Stack Technology TM (strap amps together for double power) Delayed On/Off Circuit
• Variable Low Pass Crossover Variable Bass Boost Variable Subsonic Filter 180 o Phase Control
• Pre-Amp Output Dash Mounted Remote Gain Control Direct Wire 4 ga. Power 8 ga. Speaker Terminals Direct Wire 0 ga. Power 4 ga. Speaker Terminals (2500D)

700 Watts RMS Mono Block Rubicon Series Subwoofer Amplifier

Check price now

Rerate Products

Customer Review

Oct 27, 2011 05:49:05

Ample EXONIC EX280 2-Channel Amplifier

Ample EXONIC EX280 2-Channel Amplifier Review

See more picture

EXONIC means Sonic Excellence.....by Ample Audio Anamplifiers objective is to enhance musicality and improve realism without addingunnatural character of it's own. The upgraded rugged die-cast heatsinkdissipates heat much better than the aluminum heatsink, providing morestability. By using dual power supplies, ultra high-performance MOSFETtransistors, and an exceptionally flexible crossover network, Ample has beenable to increase stability and lower distortion as well. Power, stylish andbuilt to last, the EXONIC Series of amps have quickly become the benchmark forvalue and performance in car audio.Specs :280 W MAX Bridgeable 2 Channel Amplifier70W RMS x 2 (4 ohm)100W RMS x 2 (2 ohm)200W RMS x 1 (4 ohm) BridgedDouble Sided Glass Epoxy P.C.B.RCA Inputs and OutputsLowpass Crossover Variable 30-250HzHighpass Crossover Variable 50-1KHzMOSFET Power SupplyBare Wire Set Screw Terminal Block2 ohms StableTHD 0.02%S/N 95dBCh/Sp 75dBFrequency Response 10-35,000 HzVariable Bass Boost 0-12dB at 45Hz

Check price now

Rerate Products

Customer Review

Oct 25, 2011 18:43:08

07 AND UP GM ADD AN AMPLIFIER TO FACTORY AUDIO

07 AND UP GM ADD AN AMPLIFIER TO FACTORY AUDIO Review

See more picture

07 AND UP GM ADD AN AMPLIFIER TO FACTORY AUDIO Feature

• allows clean audio quality
• plug and play
• Add A Amplifier To The Factory Audio System. Works With Bose And Non Bose Systems

add a amplifier to the factory audio system. Works with BOSE and non BOSE systems

Check price now

Rerate Products

• Boss KIT-2 Complete 8 Gauge Amplifier Installation Kit
• PAC Premium Amplifier Add-On/replacement Radio Sound System Interface Kit GM - PAC AOEMGM1416
• MRP-F300 - Alpine 4-Channel 300 Watt V-Power Series Amplifier
• 07 AND UP GM ADD AN AMPLIFIER TO FACTORY AUDIO
• Alpine SPS-600 - Car speaker - 80 Watt - 2-way - coaxial - 6.5"

Customer Review

Oct 24, 2011 01:37:03

Absolute Kit 0 0 Gauge Amplifier Kit

Absolute Kit 0 0 Gauge Amplifier Kit Review

See more picture

Absolute Kit 0 0 Gauge Amplifier Kit Feature

• 0 Gauge Amplifier Kit
• 0 Gauge Complete Kit
• 17 Feet

Absolute Kit 0 0 Gauge Amplifier Kit

Check price now

Rerate Products

Customer Review

Oct 21, 2011 19:35:17